Which cold-glue grades are candidates for coated carton seams?
M-6140, M-6145, M-6150, M-6268, M-6278 and M-6288 are folder-gluer candidates for UV-coated, laminated, varnished and metallized cartons. Their stated viscosity is 7,000–14,000 mPa·s, with a 48-hour cure reference and line speeds up to 420 m/min. Select the solids level against the actual joint and application trial.
| Grade group | Solids | Selection boundary |
|---|---|---|
| M-6140 / M-6268 | 42±2% | Folder-gluer cold glue; compare wet application and substrate absorption |
| M-6145 / M-6278 | 45±2% | Same stated series viscosity; no further pairwise distinction supplied |
| M-6150 / M-6288 | 50±2% | Compare deposited solids and drying on the actual coated joint |
| M-6050 / M-6060 / M-6070 | 35±2% / 40±2% / 50±2% | Carton flap sealing; 12,000–25,000 mPa·s; manual or automatic lines |
How should slinging or nozzle clogging change the trial?
For an M-6140–M-6288 trial, first record nozzle or disc geometry, bead placement, actual viscosity and running speed. The source benchmark of up to 420 m/min does not diagnose a defect. Compare clean applicators and controlled settings before changing grade, and distinguish dried deposits from mechanical misalignment or excessive adhesive application.
Record the first speed at which slinging appears, whether the bead remains on the glue flap and whether an interruption changes the next bead. Photograph deposits before cleaning. For spray evaluation, the stated reference uses 10 kg continuous application and an average nozzle-wipe interval of at least 30 minutes; confirm the selected grade and setup.
Which tests address carton seams that open after packing?
Use the folder-gluer references of −20°C for 24 hours and 60°C for 24 hours at 85% RH when agreeing a thermal trial. The ambient reference is 24 hours at 5–35°C, zero opening and at least 90% fiber tear. Inspect the complete joint; these conditions do not guarantee cold-chain or ocean-freight performance.
Compare printed, varnished and exposed-board contact areas using the same blank batch. Photograph both separated faces, record compression time and distinguish adhesive separation from board-layer failure. APET/PVC window patching is also a stated series application, but the window-to-board joint requires its own sample and acceptance criteria.
What should a coated-carton sampling request include?
Send the two contact surfaces, folder-gluer speed and applicator, required thermal or fiber-tear result, and packaging/documentation needs. Include a candidate such as M-6145 and whether the joint meets UV coating, gloss/matte laminate or a bare strip. Request current TDS/SDS before interpreting the 48-hour cure reference for your production schedule.
- Mark the printed face, coating and glue-free area on a sample blank.
- Give the machine, bead position, speed and time under compression.
- State when opening occurs and retain a current-adhesive control.
- Specify destination, laboratory sample requirements and 20 kg, 50 kg or 1000 kg packaging.
