LeadChem Technical enquiry

Print finishing

Soft-touch coating vs soft-touch lamination

A liquid soft-touch varnish dries on the printed sheet. Soft-touch lamination bonds a separate film to the sheet. Similar-looking swatches can behave differently once you crease, stamp and glue the carton.

How does a soft-touch coating differ from a laminated film?

Compare the complete structure: a liquid coating forms a finish on the printed sheet, while lamination adds a separate film and bonding layer. LK1033 is a water-based soft-touch varnish with a supplied 50±5 s viscosity range; its cup method needs confirmation. Approve appearance, tactile feel, creasing and gluing together.

DecisionWater-based soft-touch varnishSoft-touch lamination
What the buyer approvesThe coating over the actual ink and board, including any uncoated glue strip.The named film, its thickness, bonding layer, printed board and treated finishing face.
What to inspect at the creaseLook for whitening, cracking or a change in sheen through the fold.Look for lifting or bubbles beside the score and check how firmly the flap closes.
What meets glue or foilMap the coating boundary against the glue line and foil artwork.Check whether the adhesive or foil must bond to exposed film. Ask for the film grade's converting guidance.

Which artwork areas should a soft-touch comparison include?

Include the actual dark solid, crease, glue flap and any foil detail on matched sheets from the same print run. LK1030 provides a matte comparison at 15–30° gloss measured at 60°, but that optical range does not establish soft-touch feel. Keep the buyer’s approved tactile and visual reference beside each sample.

Use adjacent sheets from one print run. Keep an unfinished control and identify the other samples by coating grade or film reference. Include a dark solid, a crease, a foil detail if the design uses one, and the actual glue flap. Approve the look and feel under the same light with the buyer's signed reference beside it.

What checks should the soft-touch finish pass after converting?

Check scuffing, gloss change, color transfer, folds, foil adhesion and the actual bonded seam after the intended converting sequence. Rigid-box grades such as M-6123 list soft-touch film among their applications. That scope does not guarantee every film-and-adhesive pairing; qualify the named film, board, adhesive and packing conditions as one construction.

  1. Rub two finished panels under agreed handling conditions. Mark scuffs, glossing and colour transfer separately.
  2. Crease and fold in the intended grain direction. Inspect the outside fold and the edges of any laminate.
  3. Use the intended foil, tooling and adhesive on actual blanks. Retain one flat sheet and one assembled pack from each route. Record where an edge or seam separates if it fails.

Choose the construction that passes the agreed checks at the required appearance and cost per accepted pack. Approve the material stack and the converting sequence together, especially if purchasing later changes the film or board supplier.

What should I include in a soft-touch sample request?

Request LK1033 for a water-based tactile finish and LK1030 when a matte visual comparison is needed. Send the board, printed artwork, approved feel reference and downstream processes. Include the named film when comparing lamination. Ask for the latest TDS/SDS, then agree coating, conditioning, rub and glue-flap checks before evaluating samples.

LK1033 is a water-based soft-touch varnish. LK1030 is a water-based matte varnish and can serve as a visual comparison when the brief calls for low gloss. If the brief also specifies feel, include the buyer's tactile reference in the sample request.

Product values are typical ranges from the supplied specifications. Use the latest grade-specific TDS/SDS and documented substrate trials for production approval. A stated benchmark is not a result measured on your construction.

Technical references