LeadChem Technical enquiry

Technical resources

Material trial checklist

Use this sheet to compare a candidate grade with your current material on the same job.

  1. Which job and grade are being compared?

    Record the job, trial date, grade and batch reference before collecting a control sample from current production. For an M-6140 folder-gluer trial, the source-stated speed benchmark is up to 420 m/min, not a starting-speed instruction. Agree the operating window and compare the same carton construction throughout the trial.

  2. Which two surfaces will the material contact?

    Identify the board, film or foil, its treatment and the side being printed or bonded. LK1035 is listed for corona-treated BOPP, PET and paper; a film name alone does not establish surface suitability. Record both faces, any varnish or laminate, and the layer order before discussing a candidate grade.

  3. Which line conditions must stay recorded?

    Record the applicator, speed, coat transfer, drying or UV exposure, and pressure or compression conditions. For LK1048 process yellow, mercury UV is the supplied curing reference; LED suitability requires grade-specific confirmation. Change one operating variable at a time and keep the reference material under comparable conditions during evaluation.

  4. What makes the sample acceptable?

    Agree the test method, conditioning, timing and acceptance limit before running the sample. The rigid box family has a source-stated fiber tear benchmark of at least 95%, while its listed cure time is 48 h. Confirm how those measurements apply to your construction rather than substituting an immediate hand check.

  5. How should trial samples be retained and compared?

    Label control and trial samples with grade, batch, settings and collection time. Compare appearance, adhesion and the agreed storage checks at consistent intervals. For LK1037, the stated 100°C, 2 h boil result applies to its reference construction; document the actual layers and failure location before concluding whether your sample meets requirements.

Which defect should the trial reproduce?

Choose a check that reflects the actual failed pack: carton seam opening, coating blocking, film ink lifting or panel warping. M-6140 and M-6123 serve different carton and rigid box applications. Keep the substrate, sample timing and acceptance method consistent so a change in grade can be compared meaningfully.

All technical guides