LeadChem Technical enquiry

Engineering resources

Water-based ink for corona-treated BOPP & PET

Specify the film, its print face and its surface treatment. The same polymer name does not establish identical ink wetting or adhesion across different rolls, treatments and storage histories.

Which water-based gravure inks are listed for treated film?

LK1035 white gravure ink lists corona-treated BOPP and PET, with 20–30 seconds in a Tu-4 cup at 25°C and pH 8.0–9.0. LK1036 blue adds PVC film, with 18–28 seconds under the same stated cup and temperature conditions. These ranges identify candidates; adhesion still requires testing on the actual film.

Film-printing candidates and measurement boundaries
GradeStated viscosity and pHProcess / substrate scope
LK1035 white20–30 s; Tu-4 at 25°C; pH 8.0–9.0Gravure; corona-treated BOPP, PET and paper packaging
LK1036 blue18–28 s; Tu-4 at 25°C; pH 8.0–9.0Gravure; corona-treated BOPP, PET and PVC film
LK1028 general color25–35 s; cup unspecified; pH 7.5–8.5; solids ≥40%Flexo; paper, board, flexible films and labels; verify the individual film

What should be checked when ink lifts from BOPP or PET?

For LK1035 or LK1036, verify that printing reaches the intended corona-treated face before changing the ink. Record treatment history, storage, drying and the adhesion-check method. The pH reference is 8.0–9.0 for these two gravure grades, but the supplied data do not specify a universal surface-energy threshold or drying temperature.

Compare a suspect roll with a known-good roll using the same ink batch and controlled press settings. Observe wetting before drying and adhesion afterward; they answer different questions. Record whether failure occurs in the ink layer, at the film interface or after an additional coating or lamination step. Avoid adding an unapproved treatment or additive without grade-specific instructions.

Can the Tu-4 range be read directly as DIN, Zahn or mPa·s?

No. LK1035 and LK1036 state Tu-4 seconds at 25°C, which are not interchangeable with DIN 4 seconds, Zahn #2–#3 seconds or dynamic viscosity in mPa·s. The converter provides approximate international screening references only within its valid flow-time ranges; mPa·s also requires density measured at the same temperature.

Use the cup-conversion tool and its measurement limits. Retain the original Tu-4 specification in purchasing and trial records. Portions below the tool’s supported Tu-4 range must remain unconverted. For LK1028, request the missing cup method before attempting a numerical cross-comparison.

What should a film-ink sample request contain?

Name BOPP, PET or PVC, the treated print side, gravure or flexo equipment and the required color and adhesion result. Include LK1035, LK1036 or LK1028 only where the process matches. Supply measured viscosity with its cup and temperature, current pH, drying arrangement and any subsequent lamination or sealing operation.

  • Send an unprinted film sample and a marked failed print if available.
  • Record roll identification, treatment date if known and storage conditions.
  • Define the adhesion, rub or appearance test and inspection timing.
  • Request current TDS/SDS, sample packaging and destination-specific documentation.